1 / 5
Anycubic Kobra Go "FrankEnstein" cooling duct - remix — zdjęcie 1
1 / 5

Anycubic Kobra Go "FrankEnstein" cooling duct - remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of kevinakasam's FrankEnstein duct for the ender 3 to fit the Kobra Go

Ocena
0 / 5
Polubienia
25
Pobrania
99
Wydruki
0
Wyświetlenia
2014
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0
UPDATE Feb 6 2023
Tweaked 5015 duct to align better with the nozzle.

 

This is a remix of kevinakasam's FrankEnstein duct originally for the Ender 3. (https://github.com/kevinakasam/FrankEnstein-Duct)
 

I have not printed this exact version yet (added a 3rd mounting hold and a support on the section the 5015 mounts too) but it should work just fine. I may eventually update files for a slightly different setup and/or tweaks, but that will be down the road. You will need to rotate the heaterblock 180 degrees (2 small screws) and will reuse the stock ABL holder + screws

 

Hardware should be as follows, you may need to adjust lengths slightly if your inserts are too shallow/deep.

3 - m3x8 and 1 m3 nut for securing backplate (can omit 1 bolt and the nut if you want to use just the 2 top holes as I am)
4 - m3x10 for 4010 fan
2 - m3x20 for 5015 fan
6 - m3 heat inserts

 

This will need the probe offsets modified on your printer! You should be able to send an M851 to the printer via pronterface, octoprint, or similar if using Marlin firmware. I am using x+25, y0

Tagi