1 / 3
CR6SE Ultimate Direct Drive for microswiss extruder and hotend
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
All in one direct drive + 40mm part cooling fan
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 906
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 7)Remiksy (0)Kolekcje (12)Powiązane
UPDATE 15/01/2023
Added a stability clip to prevent movement, uses 2x m3 x 10mm screws with 2x m3 nuts (nuts on the inside) or alternatively superglue it to the printed shroud
printing settings
- PETG or ABS
- 40% infill
- TREE SUPPORTS!!
- ROTATE THE OBJECT SO THE HOTEND COVER IS FACING UP
- IF YOU HAVE ADHESION PROBLEMS USE A BRIM
install guide
- remove stock cover, fans
- (optional) add a washer or two to the left hotend screw on the bed leveler piece so it doesn't go down, do it if you have trouble leveling
- install the ultimate DD
- install the fan and the duct ( it wont fit if you pre install it on the DD
- install the motor and extruder with a bit of bowden between the extruder and hotend, tighten well the ptfe tube screws
- done!
you will need
- 40mm fan duct found at https://www.thingiverse.com/thing:4777287
- 4x 16mm m3 screws for the fan
- 2x 10mm m3 screws for the DD
- longer cable for extruder motor
extra
you can also install a 40mm hotend fan, i used the stock adapter with also a 40mm adapter, i used this https://www.thingiverse.com/thing:4667141
REMIXED FROM
https://www.thingiverse.com/thing:4777287 By onlydave
https://www.thingiverse.com/thing:5217783 By Phoenixcustom