1 / 7
Geometric Origami Pencil pot Pen holder with Drawer — zdjęcie 1
1 / 7

Geometric Origami Pencil pot Pen holder with Drawer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I remixed the beautiful Gerometric Origami Pot from SASSY Design to create a pen holder with a small drawer.

Ocena
0 / 5
Polubienia
10
Pobrania
141
Wydruki
0
Wyświetlenia
834
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

ENG:

I remixed the beautiful Gerometric Origami Pot from SASSy Design to create a pen holder with a small drawer. If you want you can also print more drawers. 

Alternatively you can use it as a plants pot higher than the original.

The internal diameter of the pen holder is about 80/85mm

I designed three different heights for the pen holder:
126mm
120mm
112mm

Print Settings for the pen holder:
Printer: Creality Ender 3 MAX
Filament: SUNLU PLA+
Mode: Vase mode
Support: NO
Adhesion: As you wish
Nozzle: 0.4mm
Quality: CURA adaptive layers

Print Settings for the drawer:
Printer: Creality Ender 3 MAX
Filament: SUNLU PLA+
Infill: 20% worked for me
Support: NO Without handle / Yes with handle
Adhesion: As you wish
Nozzle: 0.4mm
Quality: CURA adaptive layers

Print Settings for the drawer holder:
Printer: Creality Ender 3 MAX
Filament: SUNLU PLA+
Infill: 20% worked for me
Support: No
Adhesion: As you wish
Nozzle: 0.4mm
Quality: CURA adaptive layers

 

ITA:

Ho ridisegnato il bellissimo vaso per le piante chiamato “Gerometric Origami Pot” di “SASSy Design” per trasformarlo in un portapenne con un piccolo cassetto. Se volete potete stampare più di un cassetto da aggiungere sotto.

Alternativamente può sempre essere usato come vaso, ma più alto.

Il diametro interno del portapenne è di circa 80/85mm

Ho creato il portapenne in tre differenti altezze:
126mm
120mm
112mm

Impostazioni stampa per il portapenne:
Stampante: Creality Ender 3 MAX
Filamento: SUNLU PLA+
Modalità: vaso (vase mode)
Supporti: No
Adesione: Come preferisci
Estrusore: 0,4mm
Qualità: CURA adaptive layers

Impostazioni stampa per il cassetto:
Stampante: Creality Ender 3 MAX
Filamento: SUNLU PLA+
Riempimento: 20% per me ha funzionato
Supporti: No senza maniglia / Sì con maniglia
Adesione: Come preferisci
Estrusore: 0,4mm
Qualità: CURA adaptive layers

Impostazioni stampa per il porta cassetto:
Stampante: Creality Ender 3 MAX
Filamento: SUNLU PLA+
Riempimento: 20% per me ha funzionato
Supporti: No
Adesione: Come preferisci
Estrusore: 0,4mm
Qualità: CURA adaptive layers

 

Tagi