Mouse Holder (4x2mm Magnets)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just the original design, but with a stackable magnetic design!
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 49
- Wydruki
- 1
- Wyświetlenia
- 560
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
- Shaved the bottom by 0.25mm to make a flatter surface
- Retained original holes, but added 4x2mm magnet holes on both
This design lets you 3M double sided tape mount the top piece to the underside of a table and then stack them under each other with 4-4x2mm magnet. I mean I guess you could put them on top of the desk too if you wanted and stack upwards.
I originally printed it with 4.4x2.4 holes. The 2.4 depth fits perfectly, but the 4.4 diameter was a bit loose. I readjusted it to a 4.3mm diameter to make it a tighter fit, but haven't printed it so it's untested how snug the magnet is! I originally wanted to use 6x3 magnets, but 3mm is too thick and there isn't enough material
*Made in TinkerCad