Flux and Solder Paste Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flux and Solder Paste Dispenser for Syringes. Fits also for all other consumables in 10cc syringes.
- Ocena
- 4,915 / 5
- Polubienia
- 3234
- Pobrania
- 7956
- Wydruki
- 128
- Wyświetlenia
- 43 247
- Oceny
- 117
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- BSD License
This is a remix of the cool Thingiverse project of mordaha that I optimized for my requirements in the following terms:
- used 2x M3x20 screws as lever axles instead of 1x M3 screw and 1x filament
- levers have a bit more space to each other to move more easily
- added grip area for more precise dispensing
- added channels on big lever and main part for a rubber band or o-ring
- added fixture for an optional spring between small and big lever (outer diameter: 10mm / inner diameter 8mm), model works also quite well without the spring
- added two big lever versions with FLUX and PASTE marking beside a neutral one
Printing parameters
- layer height is not critical, I used 0,3mm
- for the piston I recommend at least 10mm brim and 3 outer perimeters to prevent stability issues
- no supports needed
- best printed in PLA
For the complete dispenser you need to print 4 parts:
- main part
- one of the big levers (choose fitting to your needs)
- small lever
- piston
I added a syringe needle cap, to easily close and open broached syringes without the need to disassemble the needle. The cap also is a remix, the original was too short for my needles.
Examples for sourcing the consumable materials
Flux: Ali Express, Amazon
Solder Paste no clean: Ali Express, Amazon
Credits
Original model is copyright 2020 by mordaha