Flux and Solder Paste Dispenser
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flux and Solder Paste Dispenser for Syringes. Fits also for all other consumables in 10cc syringes.
- Rating
- 4.915 / 5
- Likes
- 3,238
- Downloads
- 7,972
- Makes
- 128
- Views
- 43,325
- Reviews
- 117
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- BSD License
This is a remix of the cool Thingiverse project of mordaha that I optimized for my requirements in the following terms:
- used 2x M3x20 screws as lever axles instead of 1x M3 screw and 1x filament
- levers have a bit more space to each other to move more easily
- added grip area for more precise dispensing
- added channels on big lever and main part for a rubber band or o-ring
- added fixture for an optional spring between small and big lever (outer diameter: 10mm / inner diameter 8mm), model works also quite well without the spring
- added two big lever versions with FLUX and PASTE marking beside a neutral one
Printing parameters
- layer height is not critical, I used 0,3mm
- for the piston I recommend at least 10mm brim and 3 outer perimeters to prevent stability issues
- no supports needed
- best printed in PLA
For the complete dispenser you need to print 4 parts:
- main part
- one of the big levers (choose fitting to your needs)
- small lever
- piston
I added a syringe needle cap, to easily close and open broached syringes without the need to disassemble the needle. The cap also is a remix, the original was too short for my needles.
Examples for sourcing the consumable materials
Flux: Ali Express, Amazon
Solder Paste no clean: Ali Express, Amazon
Credits
Original model is copyright 2020 by mordaha