Hinge set for Ikea Billy bookcases
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hinges skinny enough to fit on Billy bookcase shelves. Additional magnet and door handle added too
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
I'm sick of dust getting into my bookcases, so I installed acrylic sheet doors on them to keep it out. I've added the handle and magnet holder files I used to keep the doors shut.
Hinges- 0.2mm layer height, 0.4mm nozzle, 50% infill, include all supports. Be careful when removing supports, because the barrel can snap during removal. The holes are meant for M5 screws!
Handle + magnet holder- 0.2mm layer height, 0.4mm nozzle, 10% infill, no supports needed (you can print these with any settings, they're not structural)
The magnets I modelled these for are 15x5mm.
The distance between Billy bookcase walls is ~36cm. I suggest designing acrylic doors that extend slightly below the lower shelf.