1 / 8
90 Degree Offset Mount for T8 LED Shop Tube Lights — zdjęcie 1
1 / 8

90 Degree Offset Mount for T8 LED Shop Tube Lights

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two-screw mount for a Barrina T8 LED Shop Light. Fits within a 2x4 height, offsets the light by a few inches.

Ocena
0 / 5
Polubienia
19
Pobrania
137
Wydruki
0
Wyświetlenia
744
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I needed to mount lights under the storage shelves above my garage door. The shelves already had limited clearance, so I designed this bracket to mount the lights flush with the 2x4s, offset a bit so the light isn't blocked.

 

Snap fit to the lights, uses the screws in the light install kit to screw the bracket in. I screwed the brackets in before snapping the light on.

 

Installed, they sag a bit. An easy improvement would be to add an extrusion on the screw mount surface without extruding the horizontal beam, then adding a screw hole on that tab.

 

I would also make the screw mount surface thicker because some of the printed parts split on the layer lines.

 

I used three brackets per light. Seems redundant enough if one fails. One bracket was enough to hold the light during installation.

Tagi