1 / 8
90 Degree Offset Mount for T8 LED Shop Tube Lights — image 1
1 / 8

90 Degree Offset Mount for T8 LED Shop Tube Lights

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two-screw mount for a Barrina T8 LED Shop Light. Fits within a 2x4 height, offsets the light by a few inches.

Rating
0 / 5
Likes
19
Downloads
137
Makes
0
Views
744
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I needed to mount lights under the storage shelves above my garage door. The shelves already had limited clearance, so I designed this bracket to mount the lights flush with the 2x4s, offset a bit so the light isn't blocked.

 

Snap fit to the lights, uses the screws in the light install kit to screw the bracket in. I screwed the brackets in before snapping the light on.

 

Installed, they sag a bit. An easy improvement would be to add an extrusion on the screw mount surface without extruding the horizontal beam, then adding a screw hole on that tab.

 

I would also make the screw mount surface thicker because some of the printed parts split on the layer lines.

 

I used three brackets per light. Seems redundant enough if one fails. One bracket was enough to hold the light during installation.

Tags