iPhone and Apple Watch charging station using Belkin MagSafe compatible charger.

I wanted a charging station for my iPhone and Apple Watch, but the ones I liked were pretty expensive. So I thought it'd be a good idea to get a regular MagSafe charger and 3d print my own, but even the MagSafe chargers from Apple cost quite a bit. Then I found these belkin ones, I believe I even got them on sale so they were really cheap, but even normally they are like $20 the charger and a wall adapter. These are the ones I am referring to: https://a.co/d/duZ2jDY

For printing I printed it standing up normally and used organic supports off the build plate only. This worked really well for this print as a lot of the portions that need support are pretty high up and not directly above the build plate, so the organic supports can come in to meet them. I printed it in PLA with a .6mm nozzle at .3mm layer height, however it should work great with any setup!

For assembly just route the cables from the watch and phone chargers through the top down through the hole to the back. I left an opening in the back so you can route the ends of the cables through there, then route them down the middle through the bottom then pop them into the cable holders so the charging station can stand flat.

A few notes:

• In the images the black one is technically my first revision, so you can see the holes for routing the cables are a little small and the Apple Watch charger opening is a little small, so I slightly crashed the mount when putting it in.
• The pink image is of an updated version where I fixed the mentioned issues as well as a few more.
• There is a small triangle cap included you can print and glue/tape onto the back opening if you'd like to cover it up, or leave it open.
• On the Belkin charger cable there is an attached rubber cable tie. This should be able to fit through the cable hole, but it may be a little tight, so it might be easier to cut it off. Though I did get it through on mine, even on the older smaller version.
• The mount for the Belkin charger fits really well, but due to the strength of the magnets can come out when removing the phone. It's not a huge issue, but you can put a small drop of glue or tap or something on the back if you want it to stick more permanently.
• This works great with my iPhone 15 pro max when turned to landscape mode to utilize standby mode!

Anyways, let me know what you think if you print it out! Enjoy!!