Unifi U6 Inwall Desk Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Stylish and Functional Desk stand for the Unifi U6-InWall AP/Switch
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 493
- Wydruki
- 5
- Wyświetlenia
- 2529
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Updated V2.0 Version now available.
Better Printability due to some geometry changes
Refined dimensions
Integrated Spacing for the Backplate to allow natural airflow to cool the Unit.
-------------------------------------------------------
A simple Unifi U6 Inwall Desk stand that i designed for my Home Network.
Official Product EU Store : https://eu.store.ui.com/eu/en/pro/category/all-wifi/products/u6-iw
The Accesspoint connects from the back and the cables pass through the bottom of the stand to make it look neat.
To attach a cable to the ports push it through with more slack than you need and connect it. Then carefully pull the slack back from behind the stand. The bending Radius should be no issue with standard Ethernet cables.
There are multiple Models available.
M4 Thread Cut requires you to either have a M4 Tap (Metric) #6-32 Tap (Imperial) or use Countersink Head 4mm Wood screws (3.5mm Wood Screws might work aswell but there is not much for them to grab onto so be careful)
M4S Inserts requires short M4 Inserts with max 4mm lenght like these https://www.3djake.at/ruthex/gewindeeinsatz-m4s-50-stueck
M4 Force fit is literally what it says and it depends on your settings and filament how well that will work. (It can split your layers or strip the hole but if careful it mostly worked for me in the past)
M4 with Nuts requires standard or even better, flat M4 Nuts
I used M4 Thread Cut
For the M4 options i recommend 4-5 pieces of Countersink Head M4x6mm or 8mm screws (8mm will stick out the back)
You can also use the included mounting hardware that ships with the Unit, they will be very long though.
If you use 3.5mm or 4mm Wood screws i recommend removing the sharp tip of the screw first
Settings:
Printed laying on its side with 5-10mm brim
Should only need support on the clear 100% overhangs but not on the 45° facets
I recommend tree supports with a 35-40° threshold Angle as seen in the picture
0.4mm Nozzle
4 Perimeters (recommended for every Version)
Layer height 0.2mm
25% Gyroid infill (recommended)
Happy Printing!