1 / 2
MPCNC endcap conduit bushing for cable protection (F-25mm, retrofittable)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple (1.6g of filament) rounded endcaps to protect the wiring. Can be retrofitted as the circle is open
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 389
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (18)Powiązane
Simple endcap for the 25mm MPCNC version.
Can be retrofitted due to it being open.
Has a larger diameter and requires some squeezing to get into the tubing but will therefore hold tightly.
The corners are also rounded to protect the wires.
Printing
- Filament: PLA/PETG
- PLA worked for me without breaking
- PETG might be better due to temperature resistance and flex
- Nozzle: I used a 0.6mm nozzle so it should also work with 0.4mm
- Layer height etc: doesn't really matter
- The smaller the layer height, the better the rounded corners (use variable layer height)
- Bed adhesion: Smooth PEI sheet for PLA
- Important since the contact surface is rather small.
- A brim is not recommended as this will leave some sharp edges
♥ If you have questions or like this print, consider leaving a like, comment or a make. Thank you! ♥