1 / 8
Circular Wireless Charger Holder + Angled Stand Option
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angled Stand for Desktop Circular Wireless Charger of 95mm Diameter
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
4Angled Stand for Desktop Circular Wireless Charger
Note: This stand is currently made for a 95mm wide charger. Remix versions can be made upon request from me or you can alter the design yourself to fit your needs.
Problems with Circular Wireless Charger
- If the phone was not placed correctly, it would fail to charge
- If the phone was shifted in the night (maybe due to an evil cat), it would fail to charge
- If the phone needed a charge, I would have to place it flat on the desk
Now with this design, solutions were made to all these problems.
Printing Notes
- Infill: 10%
- Supports: I printed without supports, but may be helpful when printing the sharp angle at the bottom of the angled stand. Also, I suggest Tree Supports for easier removal
- Other settings were defaulted on CURA
I used PLA and printed with an Ender 3 S1 Pro for this project
Easy Assembly (Shown in last 4 Pictures)
- Put the Charger Mold into the Angled Stand
- Put your Charger into the charger mold
- Put your phone in for charging!