1 / 5
Tofu60 (Redux) Wrist Rest
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A perfect fitting wrist rest for the Tofu60 (Redux) with cutouts for rubber bumpers.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 142
- Wydruki
- 0
- Wyświetlenia
- 2605
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (10)Powiązane
Jakeu's Tofu60 (Redux) Wrist Rest
IMPORTANT:
- In order to print this model, you'll need at least 256x256x80 mm of space on your bed
- You'll have to install 3M™ Bumpon™ SJ5344 rubber bumpers (19.1 x 4.1 mm) for it not to slide on your desk and match the height of the Tofu60 Redux
- Optionally, this could be printed in TPU for added comfort
Models
There are two versions available:
- Jakeu Edition (my lettering on the front)
- Blank (no design)
Printing Instructions
- 0.08 mm layer height for the cleanest look (optional)
- Tilt the model and add supports as shown on the pictures
- If you still don't know how to print it, refer to the .3mf file
Finishing Instructions
- Mask with putty to hide print lines (optional)
- Sand down with 400→600→800→1200 grit sand paper
- One coat of plastic primer spray paint (white primer for the most pop on the colour)
- Two to three coats of colour spray paint
- Two to three coats of clear coat spray paint
- Cure for at least 2-3 days since it will get a lot of skin contact
Made by Jakeu - https://jakeu.gg