Guide Rail Wall Mount - 2 Versions (Vertical & Horisontal)

If you print this model, please share pictures.
 

The Bosch FSN 1600 & 800 guide rail is 142 mm wide (see attached dimension of the Bosch guide rail and sketches of the Wall Mount in picture gallery)

The mount is a particularly smart storage solution if you have a roll-up sectional garage door as it then allows for storage in an area that is normally inaccessible but it can be attached to a wall, ceiling (be careful when mounting!) as well. 
 

It has two horizontal holes and two vertical holes to allow you to mount it in any orientation to enable you to find a stud in the wall when necessary. To adequately secure a Guide Rail, a minimum of two Guide Rail Mounts will need to be printed.

Each Guide Rail Mount is printed in two pieces, the Base and the Cam Lock. Assembly will be required after printing. 

It can be mounted on the surface using screws (in my case using a pop-nut to attach it to the VERY thinned sheet garage door, and M6 countersunk machine screws) or double sided adhesive tape.

There are various versions:

Guide Rail Wall Mount Horizontal.stl holds the track HORIZONTAL to the ground. 

If you want to mount your guide rail in a VERTICAL position there is a LEFT version (Guide Rail Wall Mount Vertical LEFT corner.stl) and/or RIGHT version (Guide Rail Wall Mount Vertical RIGHT corner.stl) that has a raised rim as a stop (see picture).  

What to print when you have chosen your version:

• If you want the HORIZONTAL mounting option, then print:

-2PCS Guide Rail Wall Mount Horizontal.stl

-2PCS Cam Lock.stl

• If you choose the VERTICAL mounting option, then print 

-1PCS HORIZONTAL.stl
-1PCS …RIGHT.stl or …LEFT.stl
-2PCS Cam Lock.stl

You can of course choose to print the LEFT + RIGHT version regardless of which orientation on the guide rail you want, but then naturally you have to be more precise with the distance between these two parts

Required additional hardware is: 

• Cylindrical head socket cap screw, M5x18mm, 2pcs
• Washer 10x5,3x1, 2pcs
• M5 Nyloc nut, 2pcs

Print settings

*Printed in PLA filament

*Use a minimum layer height of 0.2mm. Infill density of at least 15% should work well. 

*No supports needed, print in the orientation shown in pictures. 

If you have any questions or concerns regarding this model - say if this doesn't fit your guide rail of another brand, please do not hesitate to contact me.
Please kindly take a moment to show your support by giving this a LIKE and I also hope you find it interesting and valuable enough to download it! It would be really cool to see photos of your make(s). =D
Your support is truly appreciated and will greatly help me in my future endeavors! If you have any questions, do not hesitate to contact me.
Thank you so much for your support and I hope you enjoy it!

If you have reached this point - thank you! Your support would mean the world to me as I pursue my passion for creating designs that people will (hopefully) enjoy using.  If you would like to contribute, please consider donating any amount. Thank you for considering it! 
You can make a donation here:

https://www.paypal.com/paypalme/davidpersson80?country.x=SE&locale.x=sv_SE