Elegoo Saturn 2 Magnetic Exhaust Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An exhaust port adapter for the Elegoo Saturn 2 that pairs with the CREALITY K1 100MM/4" DUCT FUNNEL
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 577
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is an exhaust adapter for the Elegoo Saturn 2 resin printer. The adapter is made to work with the 4" exhaust funnel made for the Creality K1 that can be found here: https://cults3d.com/en/3d-model/tool/creality-k1-100mm-4-duct-adapter-and-duct-funnel
I printed this set for my Creality K1 to exhaust the fumes outside from my high-temp prints. I was recently gifted the Elegoo Saturn 2 and I wanted to exhaust the resin fumes in the same manner, so I designed this adapter to work with what I already had.
The adapter is made to accept 2mm X 8mm magnets but lines up with the magnets on the funnel for a great fit. You can use the hex screws that hold the exhaust plate in place to mount this adapter securely.
I printed the adapter with regular PLA, with supports only for the magnet holes, though you can probably get away without using any supports. 20% infill should be plenty for this with 0.2mm for the layer height.
I also created a simple magnetic cap for the adapter as well. I made this so that I could disconnect the exhaust hose and seal off the printer to prevent fumes from escaping.