Architect Lamp - Table Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Table Clamp will work with most Architect lamps.
- Ocena
- 4,9 / 5
- Polubienia
- 113
- Pobrania
- 657
- Wydruki
- 7
- Wyświetlenia
- 3442
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this base Table Clamp for renovation of an old Architect Lamp. The model will work with most Architect lamps.
The bolt used is a standard metric M8 x 60mm full threaded and standard M8 nut.
Tip:
As the gripping surfaces are smooth to avoid making marks when the holder is clamped on a soft surface like pine, the holder can slip on hard smooth surfaces. To avoid this, it is useful to place/glue rubber, felt or cork to the gripping surfaces.
This is also what I use, even on the original metal holders.
Have fun…
>> If you like it, please leave a like, a make or maybe a rate… :)
Print instructions
Printed without support and use right off the print bed.
There are no sharp edges for safety.
Suggested material is PETG.
Use 3 perimeters, a layer height of 0.20mm, 4 top and 3 bottom layers.
15-20% infill will make a strong part and using semi-transparent material will make the infill pattern visible (recommend Gyroid infill).
Shown model is printed in Devil Design Ruby Red PETG.