Architect Lamp - Table Clamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This Table Clamp will work with most Architect lamps.
- Rating
- 4.9 / 5
- Likes
- 113
- Downloads
- 657
- Makes
- 7
- Views
- 3,442
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this base Table Clamp for renovation of an old Architect Lamp. The model will work with most Architect lamps.
The bolt used is a standard metric M8 x 60mm full threaded and standard M8 nut.
Tip:
As the gripping surfaces are smooth to avoid making marks when the holder is clamped on a soft surface like pine, the holder can slip on hard smooth surfaces. To avoid this, it is useful to place/glue rubber, felt or cork to the gripping surfaces.
This is also what I use, even on the original metal holders.
Have fun…
>> If you like it, please leave a like, a make or maybe a rate… :)
Print instructions
Printed without support and use right off the print bed.
There are no sharp edges for safety.
Suggested material is PETG.
Use 3 perimeters, a layer height of 0.20mm, 4 top and 3 bottom layers.
15-20% infill will make a strong part and using semi-transparent material will make the infill pattern visible (recommend Gyroid infill).
Shown model is printed in Devil Design Ruby Red PETG.