Rugged case with 4 latches
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The well known rugged case with 4 latches instead of the default 2.
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 55
- Wydruki
- 1
- Wyświetlenia
- 599
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Design
I've printed the original TS100 case with the double layer remix. Sadly after a couple months of use the hinge broke off, because the lid wasn't supported.
That made me think, why not design an remix which has 4 latches instead of 2 so I can remove the lid. That lead me to designing this remix.
Printing & Assembling
I would recommend printing at a 0.2mm layer height. 4 latches are needed. Printing the TPU seal isn't needed unless you want to water tighten the case. The latches and hinges are made to fit M3x20screws. CA glue can be used to fit the inserts and case halves together. However in my case the inserts fit the case so well, I didn't even need to glue the two together.
Additional parts like the latch kan be downloaded from the page of PjotrStrog's page.
Sample specifications
The samples shown in the image are printed with Polymaker Polyterra PLA gray and Polymaker Polyterra PLA Charcoal black.
Special thanks
Thanks to PjotrStrog and Aikano9 for the original design.