52mm (2-1/16th) Panel Hole Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A basic hole cover to fill in 52mm holes in any panel / dash / fascia.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 44
- Wydruki
- 1
- Wyświetlenia
- 109
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
A basic panel / fascia / dash hole cover designed to pop into and fill holes of 52mm (2-1/16”) diameter and approximately 3mm thickness.
Material should be chosen to suit the application, however, for anything in cars or boats etc that will be in the sun it should be PETG as a minimum.
Supports will be required unfortunately and care should be taken during removal to ensure the locking tabs aren’t broken if printing with the face down. Layer height and line width aren't particularly critical, the example shown was printed at 0.2mm height and 0.6mm width.