Spacious ESP32 enclosure, magnets on bottom, DHT11, 4x-Dupont Pin-out, snap together, no screws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for an ESP32 dev board with Pins still attached and room for wiring inside. Can take 2 Magnets and and a DHT11
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 504
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
ESP32 devboard enclosure, big enough to keep the pins attached and use Dupont connectors to the ESP.
The enclosure is designed for an ESP-32 Dev Kit C V4 like this one, but should also work with other boards of the same size, as the board is held from the sides.
There is a opening on the side to fit an DHT11 temperature / moisture sensor.
On the other side is an opening for a 4-pin dupont connector. I used a drip of hot glue to fix an angled pin header for taking the Dupont-connector from outside.
In the bottom you may optionally place up to two 12mmx3mm round magnets, allowing the enclosure to be placed to any metal surface like a switch cabinet.
I used it for my Hitchi IR reader on a cable, to place the ESP32 outside of my switching cabinet for better WiFi range.