Spacious ESP32 enclosure, magnets on bottom, DHT11, 4x-Dupont Pin-out, snap together, no screws
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for an ESP32 dev board with Pins still attached and room for wiring inside. Can take 2 Magnets and and a DHT11
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 34
- Makes
- 0
- Views
- 506
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
ESP32 devboard enclosure, big enough to keep the pins attached and use Dupont connectors to the ESP.
The enclosure is designed for an ESP-32 Dev Kit C V4 like this one, but should also work with other boards of the same size, as the board is held from the sides.
There is a opening on the side to fit an DHT11 temperature / moisture sensor.
On the other side is an opening for a 4-pin dupont connector. I used a drip of hot glue to fix an angled pin header for taking the Dupont-connector from outside.
In the bottom you may optionally place up to two 12mmx3mm round magnets, allowing the enclosure to be placed to any metal surface like a switch cabinet.
I used it for my Hitchi IR reader on a cable, to place the ESP32 outside of my switching cabinet for better WiFi range.