X-Shot Longshot - Plunger Tube Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Printable replacement plunger tube for the Zuru X-Shot Longshot.
- Ocena
- 4,857 / 5
- Polubienia
- 57
- Pobrania
- 453
- Wydruki
- 6
- Wyświetlenia
- 2098
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple 3D printable tube to replace a cracked plunger tube on an X-Shot Longshot. I recommend printing this with Orca slicer and scarf seams enabled to get the best inside surface finish. Attached .stl file and a .3mf file for use in Orca slicer. The 3MF file is set up for my Prusa Mini and worked perfectly with a great inside finish.
The inside diameter is a bit smaller than stock at 39.5mm and has 1.8mm thick walls. Recommend at minimum coating the inside of the tube in a thin layer of grease, I used SuperLube, but anything plastic safe is probably fine. Also, sanding the interior walls for a smoother finish would be beneficial, however I didn't do this and it works fine.