RC Yamaha Sr Viper 1/6 Modding Parts

This is a DIY starter kit, you NEED a base model Kidztech 1/6 Yamaha and you WILL have to cut parts of it and add hobby grade electronics for this to work at all !
I can help for difficult parts, just ask in the comments

APRIL 2019 UPDATE : Pascal made his V1 files available on Thingiverse, this means i can now release all my modded files too !! THANK YOU PASCAL !! :D
Link to his Polaris Rush page : https://www.thingiverse.com/thing:3581090

If you need a replacement bulkhead that will fit without any mods see my original part here : https://www.thingiverse.com/thing:3265111

• The rod-end i used are Traxxas TRA1942.
• The front shocks i use are RC4WD Shocks 80mm w/ internal springs, 10mm diameter.
• All the bolts and nuts are M3, mostly M3x16 but some M3x12 and M3x20.
  You will also need a 3mm steel rod, long enough to cut and make axles for the front and rear upper skid mounts and a way to keep them there (set-screw collars).
  You could also use some long M3 all-thread rods cut to lenght and some nuts.
  Of course, a couple of drill bits can adapt those parts to any size rods or screws you might have laying around !

* UPDATE: With "promod_bigshock_upper_Aarm" you should be able to fit up to 15mm diameter shocks !

* UPDATE: Use "promod_bulkhead_higher_shock_mount" for longer shocks (Should help fit shocks up to 90mm or 100mm with limiters) !
To fit the long track conversion, you will need to remove the factory On/Off switch from under the seat and grind the white plastic hump underneath flat, or your track will rub on it.

Print instructions

Category: R/C Vehicles