MGN9H rail convertion kit for BaGoon's insert press
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just a adaption kit for the MGN9H rails since it did not fit the original design and I had already printed out t
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 70
- Wydruki
- 1
- Wyświetlenia
- 496
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
You can use these parts this with this model https://www.printables.com/model/808502-heat-insert-press
I had already printed out all the parts before realizing that the 150mm rail I had was not the one I needed for this press. Still, I was already set on finishing it now and could not be bothered to redesign the arm/holder, so I made a conversion kit instead.
I used 4 pcs of M2 heat inserts, the longer the better I suppose, I used the longest one I had.
I have a cheap printer so this might not be an issue for you, but it was a bit tight for me, just like the original parts and I put the rail on and used an extra long M3 screw to press the M3 nuts into the nutbar before I mounted it in place, the good news about that is they will not fall out I guess.
I hope someone else also needs this.
if you need M2 heat inserts you can get some on Aliexpress with my affiliate link here: