Liczymy pasujące modele…
2004-2005 Honda Civic Si EP3 parking brake trim parts. Original parts were a natural color plastic with chrome plating, which wore out. Then the plastic broke. I made these repair parts, and used plastic epoxy to glue the new trim part…
These TPU retention sliders hold hydrofoil T nuts in your desired position between sessions. They speed up assembly and disassembly before and after foiling sessions. They are easy to install, and slide to reposition with a hex or torx…
Gcode for MK4 in PETG Hatchbox. Manual layer change to produce the bi color lettering. Design is near a match for the V3 GONG high modulus carbon mast, with slight adjustments to make it symmetric to use for either nose up or nose down…
This print slips onto the end of a 1 - 5/8 inch outer diameter steel pipe, which is set in a heavy cast iron patio umbrella stand. Light strings hang from this part, and are staked out around the umbrella stand, to create a lit Christmas…
Printable wall mount brackets, to use ½" PVC piping to store rolled materials. I used this with a roll of white paper to use as a background for taking pictures of models in my garage. Could use for storing christmas paper over a wrapping…
NU = Board Nose Up (meaning there should be more front foot pressure needed) ND = Board Nose Do (meaning there should be less front foot pressure needed)
Print in TPU, without supports, 1 top and bottom layer, 2 perimeters, 10% infill gyroid. Position with the flat surface on the build plate. You can increase print speed significantly over the defaults. Recommend printing one at a time, to…
Print in TPU. No Supports needed. Use a bungee to make a loop through the hole, and it goes around the hydrofoil to hold it in place to protect the foil when it's not in use and disassembled.
To wszystkie aktualnie dostępne wyniki.
