Liczymy pasujące modele…
Trays, dividers and labels to fit the Ridgid Pro Gear 2.0 Drawer toolbox. Should also fit Keter, Magnusson and other rebrands. You'll probably need to print the divider on the diagonal, and the trays standing up at 45 degrees with some…
Two sets of wheels for the Tamiya Blitzer Beetle, but should also fit Stadium Blitzer and Stadium Thunder and mostly likely other 2WD Tamiya models which have ball-bearing front wheels rather than the 12mm hex found on most aftermarket…
Steering servo arm for Tamiya Blitzer Beetle / Stadium Thunder. Most likely works with other Tamiya models with same type steering linkage. Note that this is only a part of the servo saver assembly and is not threaded to fit directly onto…
I designed this to utilize the empty space where the stereo head unit was when I installed an Android unit. Prints in two parts. Print the faceplate facing up and break off the designed-in supports. Glue the box into the back of the face…
Holds 16 Chisel Tip Sharpies Print instructions Category: Art Tools Summary Holds 16 Chisel Tip Sharpies
This model encloses the electronics on the Tamiya Blitzer chassis to keep the dirt, dust, grass and leaves out and secures with a standard body retainer clip. Designed around a Blitzer Beetle, should fit other Blitzer chassis models. (Let…
Original battery pack died and the 2s drone batteries don't fit in the stock location. These were designed around Tattu 2s 550mah batteries that are about 60mmx15mmx18mm but are oversized to accommodate possibly larger batteries. Use…
This is a 25x25 motor mount that will allow a motor with an output shaft on the rear of the motor to be installed in the plane. Includes the correct right/down thrust angles. Print at 100% infill.
Replaceable end caps for RAM Mount Tab-Tite tablet holder. The end caps that come with the Tab-Tite are generic and far too large for my tablet. These are designed to fit the Huawei MediaPad M5 8" Tablet. Feedback welcome. Category: Tablet
My kid wanted one of those "kid safe cardboard" chompers but I'll be damned if I'm paying $250 for one of those so I built this for about $65. Designed for a table surface of 15.5mm thickness. (I built mine into a random side table from…
Sony Bluetooth speaker points straight up, unfortunately that's not where my ears are. This little reflector cone pops on the top and uses a parabolic reflector to redirect the sound outwards instead of upwards.
To wszystkie aktualnie dostępne wyniki.
