Liczymy pasujące modele…
Tool to remove/align the button bezel on Emisar and Noctigon flashlights, useful to replace a torn or dirty switch cover or repair a faulty switch Version compatibility: 6 spoke: D1v2, D1K, D4K, DW4, DT8K, DM11 (new), M44 (maybe) 5 spoke…
Replacement for BMW 52 20 8099555 rear seat side bolster clip Designed for my e46 coupe after the clip broke when removing the bolster panel and I found how expensive a replacement clip was to obtain. Likely fits other e46 3 series, e53…
Printed on a 0.4mm printer, 6 perimeters. 65mm/s on my Ender 3 v2 but should be fine at higher speeds I used PLA+ but PETG should work even better. Not compatible with clip, remove it before use. Tried to incorporate but didn't work well…
Small protective box for the flashing kit for Emisar and Noctigon flashlights. Should also work for other USBASP flashers. Might require a bit of fitting on the USB connector's hole, I manually enlarged it a bit using a knife,…
This is a tool to remove the bezel of a Emisar DW4 flashlight, to replace the glass or switch the optics. I use this tool often and it has been very useful. I had this model saved for a while and cannot find it online anymore. I am unsure…
Print in Vase mode, no floor layer. Should take only 40-50min in most 0.4mm printers. Might need spacers to work in a 26800 flashlight, I used 4 of the Convoy 26mm spacers for my D4Sv2. Printed using 0.4mm Ender 3 v2 Designed in FreeCAD…
Printable cover/box for the Wurkkos/Sofirn firmware flasher (attiny1616) sold by u/the_gchart on r/flashlight and thefreeman on BLF. Makes it easier to hold steady without touching the electronics of the PCB. Made for the USB-C model.…
Tool to make it easier to install the pressed-in button ring of the Emisar D4S and D4Sv2 Print with 100% infill, ≥4 perimeters. PLA+ is fine
A spacer to use flat top 18650 batteries in the Emisar D18, without taking the polarity protection rings off. Hard to get high quality button top 18650 batteries where I live so I designed this. Takes 10mm diameter cylindrical spacers,…
This ring of plastic is inserted between the optic and the top of the threads for the bezel, so that it fills the gap between the optic and the head of the light. This was made after a friend overtightened their light while trying to fill…
Modified the design so it uses the brass buttons from the Convoy 4x18 and 3x21 buttontop adapters/spacers. This should be safer to use, and also have a lower resistance. To assemble: 1) Push out the brass buttons from the original Convoy…
To wszystkie aktualnie dostępne wyniki.
