Liczymy pasujące modele…
These socket organizers were inspired by using socket sets on the deck of a sailboat. You want them to stay together and not roll off - nor rust. The sockets, extensions, and wrench will stay on the holder and resist removal unless tilted…
The Waterpik traverler was designed to use the reservoir inverted as a cover but it would be nice to have a set on cover once you are where you are going and set up. This is that cover. It sits inside and on top of the reservoir with two…
A friend was facing replacing a whole Navico Wind Direction and Speed system on his 30 year old sailboat because he was unable to find a replacement wind cup. So I reverse engineered the hub, cap, and cups for the Navico System 200 WD200.…
The flexible hinge of 30 year old Nutone Intercom IMA-4006 fail and this design printed in Nylon at 100% fill without supports takes about 4 minutes to make a replacement part.
Replacing the batteries in WP560 Portable WaterPik requires a careful destructive removal of the battery (and motor) case bottom to get access to the batteries. This part is a battery door or bottom to use for re-assembly. Print Settings…
Discovered the HEX to Round bearings at the drive end had worn out which allowed the cutters to bang against each other. Made a couple of bearingV0.3.stl in 618 transition nylon to use in the non drive end. Swapped the bearings from the…
To wszystkie aktualnie dostępne wyniki.
