Liczymy pasujące modele…
All around best spool holder design that requires no support and mounts with common screws. It has been tested with a 1 kg spool and can be mounted in various positions. This is perfect for mounting in an enclosure, on a wall, under a…
Mount opening is 1.6 inches inside diameter. I redesigned this with a thicker mount bracket than what is pictured as my original was a little flimsy. I recommend this with an LED bulb only. If this design gets enough interest I'll update…
Very strong pulley that uses a 608 bearing. I designed these to be easily mounted with wood screws and to withstand a lot of weight. They work great with paracord and can be used for a lot of different projects. Instructions : Use infill…
UPDATE: I have added 3 new STLs which require no support for decreased print time! I will leave the original 3 up for those that need some to really lock closed. I have also added the gcode files for bulk printing on the MK3S+ with PLA.…
One of my old designs but is a battery adapter so you can use C cell batteries for a D cell flashlight or whatever else you need these adapters for. There are two STL files. One is just your basic adapter with no cutouts and one has…
Just a simple handle. Uses two wood or sheetrock screws. Adjust infill density as needed.
Coffee pod holder for your nespresso original line pods. Print Instructions: Use 0.2mm layer height, 15% density. Check out my other designs!
This is for a screwdriver shaft that has the two flattened tabs on the end (see picture). It took me awhile to dial in the inside diameter for the screwdriver shaft and I left it so you must use some force when installing for long term…
Print Instructions: print with support.
This is a coaster that was designed to slide on the arm of the couch. The inner dimensions are about 7 inches. Drink base diameter is about 3 inches. Instructions : Print on the end with the indent hole down. The indent is very small but…
Reusable CG stencil for various projects.
Note: This design has not yet been tested. Please read. I was looking for a large printable propeller that I could paint and put up on the wall. I redesigned this with much higher resolution and sliced it down to five pieces for…
Uses a pin to hold a lanyard or string and can do repeated releases with no noise in accelerometer data. There are two different bracket designs, one has a larger pin release opening. Make sure you have an extended phillips driver bit.…
Dual ½ inch PEX flange for hot and cold water lines. This is a snug fit, if it's too tight then scale up 1%.
To wszystkie aktualnie dostępne wyniki.
