Liczymy pasujące modele…
The combo port on my X13 was the bane of my existence, so I made a nice little cover that leaves the USB C port exposed, but hides the proprietary mini-ethernet connector. This is a very snug fit ! Once installed, it takes something…
A caddy for your Dell DELL MZ60045 caddy: a caddy². It fits 3020 7020 9020 SFF PCs, and possibly others. This allows you to repurpose the optical drive slot on your Dell caddy, and mount a 2.5" SATA drive in its place. Drives clip in and…
An IKEA SKADIS mount for your mini-ITX motherboard. It's designed for the AsRock N100DC-ITX, but will most likely fit other boards, too. It's very sturdy , prints without supports and if parts are positioned as recommended, layers will be…
An easy-to-print, snug fitting little mount for the ole' Archer. Assembly For the correct orientation of parts, refer to the non-plated 3D model. Slide the feet on the cages Mount cages on both sides on the router, hooks outside Hook the…
This design fits the well-known IKEA SKADIS and this specific case: https://shop.pimoroni.com/products/aluminium-heatsink-case-for-raspberry-pi-4 - there are many more like it which look very much the same, and will probably fit. In case…
The Y1MD14100 spacer that comes with the FC-M6120 is a tad too large in diameter if you're pairing it with a higher-end, XT level BB-MT800/BB-MT801 bottom bracket. Instead of that, you need a Y1PW98070, the stuff that comes with the XT…
This should fit most old combo levers from that generation, mine is a ST-M075 if I'm not mistaken. Bell clamp should be 10mm wide, and a standard 22.2 clamp - I designed this around three of those typical little black bells you get with…
A IKEA SKADIS mount for the RT-AX59U that uses the factory base/backplate as a part, so you don't lose that bit of plastic to some junk drawer. It's not a robust mount, so make sure you print it from strong materials. If you push on the…
To wszystkie aktualnie dostępne wyniki.
