Liczymy pasujące modele…
This is a model that has been remodeled from a previously manufactured sand scoop into a 130mm form. There is a slight difference between the modeling in the drawing and the printed photo, but after printing it was modified to slightly…
This is a sand scoop with a diameter of 100 mm.(about 4 inches)The height is about 150mm. (about 6 inches) It can also be used to filter out cat poop. The material used was PETG. ADD Added 5mm hole type for cat poop shovel.
This is a bracket that can be easily mounted on the extruder when installing an acceleration sensor on the Ender3 v3 se. When printing, it must be printed in the same form as shown in the example to receive force when inserted into the…
This is a hard bait storage container that can be used on both sides. It can store metal jigs, minnows, egi, etc. that are less than 100mm long. There are five compartments on each side. Each part requires some support due to protrusions,…
I did some decor tiles in the room. To apply the bond evenly, I needed a tile scraper. I could buy them and use them, but I have a 3D printer so I'll have to make them. It was modeled to be approximately 4 inches by 6 inches in size.
It could be made a little simpler, but I thought it would be more useful if it was firmly fixed, so I made it like this. A vent hole is created inside to facilitate air discharge. So water can enter better.
I suddenly got a parrot, so I thought about a toy I could play with. It has the shape of a hollow dumbbell-shaped rolling barrel and has a rattle inside that produces sound. The caps on both sides can be assembled by snapping them…
Since I use a dryer, I no longer need the filament top holder. The location of the runout sensor could be fixed to an existing holder and used, but the location was a bit poor. The concept is to allow it to be inserted into the frame at…
These are ring tongs that can be used for many purposes. The first reason for modeling was to design curtains to be installed inside the vehicle. I was thinking about curtain clips for moving a 20mm stainless steel pipe. Through several…
This is a runout sensor bracket for use in a new location rather than the existing filament holder. I purchased a filament dryer, and in order to send it directly from the dryer to the extruder, I couldn't use the existing runout sensor…
I purchased a Nebula camera to increase the usability of my Ender3v3 printer. I looked for a printer bracket on cloud, but couldn't find a suitable model. So I did a new model. At first, I was in a hurry and tried to install it in a…
This is a waterer for dogs or cats. There are two types of modeling. For beverage bottles and PET water bottles. Beverage bottles can also be used if printed for PET. I think it would be best to print with PETG if possible.
It became necessary to repair water pipes. I needed some plumbing saddles, and I needed them to be easy to install and release. Ender3V3, 0.3 layer height, 35% cross hatch infill, PETG, about 1H print time The outer diameter of the…
I had a need to cut a certain amount of plywood. However, I didn't have enough space to make a large bed. I made a simple guide to cut it to the same dimensions. The composition is as follows. In the configuration, the square pipe is a…
I wanted to use a bento box, but it was difficult to find a filter. So, I made a case using only HEPA filter paper, which is relatively easy to obtain. I'll leave a link to the products I used. Please refer to it.…
I had an old icebox. It was in good condition, but I lost the drain cap. And the cap that connects to the air bubbler I was using for fishing was broken. I made new caps to replace them. My icebox is the same brand as this one and I think…
To wszystkie aktualnie dostępne wyniki.
