Liczymy pasujące modele…
I liked the original minimalist design of the wedge, but ran into some issues with it not staying secured to the Bowden tube and the dryer itself, so I added 2 set screws for holding onto these parts. I also added a M6 tap for a Bowden…
This is a two piece, parametric Picatinny sling point, optimized for 3D printing. Pictured on an airsoft P90, printed out of PC-CF. Bill of materials M3 nut, optionally a locknut M3x35 Printing instructions The fits here are optimized for…
This is a fork of the 4 Axis PCB Stencil Printer with Rotational Axis by Philipp of Dengler Mechatronik GmbH . A stencil printer is used to apply solder paste to printed circuit board, before placing components on them. This one enables…
This is a two piece, parametric MOLLE cylinder (smoke grenade, flashlight, bottle, etc.) pouch with elastic cord retention. While the exported models here fit Polish ED-60 and GD-10 smoke grenades, and a Olight Baton 3 flashlight, you…
Pixhawk 6C Mini doesn't have a traditional 30.5 x 30.5 mm flight stack mount, instead opting for a zip-tie or adhesive-based mounting, with the recommendation of mounting a flat plate above your stack, and fixing the controller on top…
This is a simple sock/cover for Storz & Bickel Venty, meant for printing out of foamed Varioshore TPU for feel and impact absorption. Buttons are covered away on purpose for moisture ingress protection, but if there's any interest I'll be…
A dial indicator holder for Proxxon MF70 that screws onto the spindle shaft and uses a Noga FA1410 holder (part of Noga PH2040) to mount the indicator It shouldn't be too complex to manufacture the compliant dial holder part itself…
This allows you to generate any size of a magnetic pen holder/generic bin, with any size of magnet holes, allowing you to use whatever you have on hand. Source code can be found here . Attached are the 3- and 4-pen variants with 5x5 mm…
Mount a smaller version of the LumenPnP's datum board, without moving the primary fiducial, to enable 3D calibration. This is second revision of this model, moving the secondary fiducial to OEM secondary fiducial location, removing the…
Parameteric 1x1 Gridfinity solder spool holder using a 608 bearing and M8 bolt to achieve unlimited spool width. While other holders either build a fork around the spool, limiting its maximum width, or insert the bearing into the spool…
This is a mount for the Framework printable case I used to attach it to my LumenPnP. It mounts on the lower left extrusion, right next to the the control unit, enabling easy cable routing. Printing To print, print two copies: one as-is,…
To wszystkie aktualnie dostępne wyniki.
