Liczymy pasujące modele…
A protective case with a cable clamp for a XH-M604 Lithium battery charge controller. Note this a new design and I will not be able to print this for a few weeks but if some one wants to have ago please feed back if all dimensions are OK.…
We have two bikes hence the plug holder is designed for two charging plugs but the holder for the body of the charger holds one only. The slicing file is for Prusament PETG and has paint on supports, infill is 15%.
This is a fixed in place adaptor, the battery sits in close to the tool and looks as close to a factory design as possible. You will need some copper sheet 0.5mm to about 0.9mm and small screws. It the copper is untinned copper you will…
The top of the tool holder is an interference fit and as such must be printed in a flexible material, I used Esun 95A TPU, the bottom I printed in PETG both with 25% infill and did not use any supports. It is just large enough for a 29er…
Recycle your old NiCad Powered Makita battery drills. I was given this 14.4 volt drill and the NiCad battery's by a builder who was moving on to Lithium battery based tools. The NiCads for the old drill was well past Its use by date, so…
The goal of this design is to protect the suspension linkage bearings from mud, grit, water etc. which reduces their life and keep the bike a little cleaner. The guards are printed in PETG, and held on with cable ties, I prepared for 6…
The holder keeps it close to the wall so useful where space it at a premium, for my intended use I added some soft material and "O" rings to prevent damage during driving due to vibration. Printed in PLA abut 15% infill no supports…
This printed alternative to a commercial funnel helps prevent spreading coffee on the bench when filling the portafilter and when tamping the coffee. Suits a 2 ear E61 portafilter. I printed upside down, no supports, 25% infill. The…
This vent cover has a screw in grill to make cleaning easier. It is intended for mounting under eves/soffit or inside the house, I would not use it where it would be exposed to direct rain with wind unless you fit some sort of cover. It…
The LTC1871 is a simple boost converter ex Ali Express that needs a case. I use mine to power a 19 volt laptop from a 12 volt supply. The case uses 2mm diameter screws to hold the lid on, and cable ties pushed around a "horse shoe shaped…
Tamper printed in PETG, no supports, I added some extra layers on the bottom to stiffen it up and 30% infill. The funnel in the image is also available
I was not very happy with the wheel speed sensor cable management on my Whyte E160 so I made this small guide to ensure a stick or other cannot push the cable into the back wheel tire which would ruin a day of riding. I think it will suit…
Star Trek Enterprise plan view, made to add depth to a painting, printed in dry PLA, 15% infill.
All printing in PLA at 15% infill no supports 0.2mm layer Note this device uses mains power so if you are not confident with mains power (110V or 220V to 240V dependent on your country best not to try this) Manage the charge in a 10S lipo…
To wszystkie aktualnie dostępne wyniki.
