Liczymy pasujące modele…
I have a bunch of Menards Xtreme garage shelving for storage. I wanted hooks that fit the sides of the shelves so I designed these. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 Plus Rafts: No Supports: Yes…
Nose wheel mount, main gear mount, and motor mounts for use on the FliteTest Explorer RC airplane kit print nose wheel mount with the sloped face down so that no supports are required. The control horn mounts with the control arm down so…
I could not find a decent 45 degree mount for the Wyze Doorbell Pro model. The one I did find had a 5mm gap between the mount and the doorbell. So I created my own. This version has near-zero gap between the doorbell backplate and the…
The original Timber wheels have a habit of tearing away from the hub over time. These replacement wheel hubs grip more of the tire and should prevent the issues in the future. They also prevent the tire from rubbing on the landing gear.…
The firewall is not available for purchase from horizon hobby except as part of a whole fuselage. My plane was fine except for the smashed motor mount and firewall. So I designed this printable replacement firewall. It is compatible with…
Flush mount I use for my FliteTest airplanes. The servo slides in very tight. the cover just holds in in place. It fits HXT900 and SG90 servos. MG90's should also fit but have not tested. The V1 I have used twice but the cover does not…
This is my 3rd version of landing gear for the E-flite Opterra. Version 1 and 2 used double sided tape to attach to the unmodified keel of the plane. On a semi-hard landing I managed to break the plastic keel instead of having the tape…
Oversized Pencil sharpener I designed for shaving the ends off 1/2 inch PVC pipe. requires the blade from a carpenters pencil sharpener: https://www.homedepot.com/p/C-H-Hanson-Pencil-Crayon-Sharpener-00202/100494160 Print Settings Printer…
The original mix of the seaduck cowl had to be printed nose side up to get a good print out of it. That required A LOT of support. I sliced the cowl nose off so that it could be printed in two pieces: nose ring with nose up, and rest of…
I couldn't find any cases that matched my criteria so I designed my own. Access to ALL ports on the Pi 3b+ Simple to assemble Small as possible (with preference to low instead of thin simple to print Holds Delta 5 / Rotorhazard board…
Friend broke the wheel hub on his carbon cub 1.3m. I designed and printed replacements for them. I recommend printing out of PETG. Glue using standard CA. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 Plus Supports:…
I crashed my Flyzone Gee bee and destroyed the motor box. I designed this to replace it. I removed the steel balls that were there for weight. instead you can ether print this with more infill, or use stick on wheel weights inside the…
To wszystkie aktualnie dostępne wyniki.
