Liczymy pasujące modele…
This is the main body that has been shortened to 216.5mm so will print on the Creality K1 bed that has a build volume of 220x220mm. I tried 219, 218, 217 mm but all caused negative x movements, so 216.5 is what worked for me. You will…
This design will fit spool with center holes from 80mm down to 36mm. Uses 2 6200 series bearings instead of 4 like the original. The idler end bearing holder is attached by a M5x25mm cap or counter sunk screw. And for the driven side use…
The holes for the motor are slotted to allow depth adjustment. The hole at the rear of the winder main body are slotted to allow for different lengths of the main body. Parts required: 4x M3x8 Bolts 4x M3 Nuts 6x M3x4 Inserts See the file…
Surface Grinder Wheel Balance. This balance was modeled for the wheel balance shank that came with the Chevalier Falcon FSG-618M. Balance shank must be at least 95mm long and approximately 15mm in diameter. Supports up-to an 8" wheel.…
The filament center acts like a mini spool for loose filament and allows for easy swapping of the master spool for Sunlu filaments found on amazon . The inner slots allow for straps to be placed around the complete assembly or just the…
ESP32_Devkitc_v4 Case This is a case for the ESP32_Devkitc_v4 (28X48mm PCB) that will accommodate an ESP32 with pcb antenna or ufl external antenna. Printing: No supports Tested with PLA and PLA-CF Well calibrated printer. Tolerances are…
If you child is at that age of opening doors and you keep some doors locked like the laundry room, then this gadget makes unlocking the door easy for the adults. The door lock guard is just a friction fit on the Schlage Accent style door…
This is a mount for the cheap thermostat units like the Inkbird ITC-1000. It will mount to the edge of something. Mounted to a 2x4 stud the flange will stop in the middle of the short side.
This is essentially a remix of 3147295 that moves the PiCam closer to the Z frame and hangs the PiCam under the mount. This works with a PiCam v2 . Note: You will probably want to focus the PiCam with the nozzle in the middle of it's…
This is an anti-spill ring for the Freemax Mesh Pro atomizer with the bubble tank installed. Version 4 is 11.50mm radius and fits very well. Version 5 is 11.25mm radius and is for those that like a snugger fit. You do not have to remove…
To wszystkie aktualnie dostępne wyniki.
