Liczymy pasujące modele…
I modeled the Punisher Skull and added it to the Short 2 IPT file in this source. https://www.thingiverse.com/thing:580466 I found this one https://www.thingiverse.com/thing:2742432 on here, But my slicer didn't like it so I made one. I…
This LCD cover is to fit the Big Tree Tech TFT35 V3.0 on a MK3/S Bear frame. In this design the supports are held in by 4) 3mm x 8 screws, which also hold the board in the cover. Trying to think of a better way because there isn't much…
I remixed this case https://www.prusaprinters.org/prints/20416-skr-bear-case to make room for the WIFI chip on a Bigtreetech SKR V1.4 There is 2 options V1 has the chip extended outside the case V2 has the chip enclosed inside the case…
Remixed this design https://www.thingiverse.com/thing:3007637 to be able to print the handle with the base one the build plate without the need for supports. I was able to leave the tabs on the model after printing with no issues so far…
I was asked to make a M-Lok version of my previous foregri, here it is! Designed for .2 layer height with no supports Once printed you will need to use a knife to open the bolt holes, I purposefully made one .2 layer across the hole so I…
This is feet and caps for the storage units that Home Depot sells, the HDX Heavy Duty ones. See pictures, this fits the 18 and 24" versions of this same shelving. I used these storage units in a place where I could only use 3 of the…
New design of the Artillery Sidewinder X1 fan shroud. It was designed off a Prusa MK3s Bondtech BMG fan shroud with Joel Nicklasson's fan bracket, but designed to mount to the original fan mounting location. This shroud sits close to the…
I always wanted to try some linear rails on a printer and with all the people having issues with the ribbon cables on the SWX1 (I haven't yet) I decided to remix the Bondech BMG Prusa extruder to put on this printer. Remixed the extruder…
I printed these out to have two same height items to support the X carriage on the Sidewinder X1 while I was made adjustments. These were designed for the V3, the V4 has the ribbon cable connector where this was designed to go. May still…
This is a repost of my fan shroud. I used PETG to print this shroud and haven't had an issue so far with sagging, but I also have a heat block sock on my machine. With how close this is to the heat block it may be best to print this in…
I got tired of adjusting the spool holder every time I changed filament, so I made some rollers that fit over the stock bearings and fits up to a 70mm wide spool. You will need to remove one flange bearing from each of the original…
This is for the new version of the Home Depot RBL (Jumbo C9) they sold this year, which are smaller than older versions. This is to put 5) 12mm bullet nodes in the RBL lights Print instructions Unassociated tags: HD RBL, Jumbo C9…
Warning: as of 7-21-2019 Joel removed his design from FB for a redesign allowing for the stock X endstop position. I don’t know what the issue was/is as I have not printed this carriage nor do I use it. Note: Because of the fact that it…
I didn't like the normal green base to the Home Depot RBL lights and I wanted these to go to a 3/4" PVC for path lighting, so I designed this replacement base. This is for the lights that were sold this year at Home Depot, which are…
To wszystkie aktualnie dostępne wyniki.
