Liczymy pasujące modele…
I've had my JBC iron for about 4 years now, and it lacks the fancy built-in storage for C245 cartridges like the new models do. This is my V2 of the 3D print I have been using to store extra cartridges for about 2 years now. This version…
This is a holder for the Kica JetFan battery-powered duster. It is made to accept mounting screws up to 5mm in diameter or zip ties like I have done. The design is primarily focused on holding and keeping the jetfan from spinning around…
I remixed this to accept 1/4 NPT fittings and increased the hole size for the original power cable (you will have to unpin the wires from the connector and then repin them after putting them through the hole). Do note YOU MUST TAP THE…
I remade the original X-axis stepper mount so that it would be compatible with all configurations/variances/etc. of the X-axis on the Prusa MK3(S). This design relies on the underside of the stepper motor for keeping the mount from…
This is an E-Stop mount for any 2020 extrusion frame CNC such as the 3018. This is designed to be mounted on the right-hand side of the x-y frame, with just enough clearance to clear the work-table. Parts needed: 3x M5 screw for mounting…
Simple bracket and bottom retaining mount for Drierite gas drying units. My particular use case is for my cryocooling LN2 generator. Holes are designed to accommodate M5 hex socket cap bolts, but with a washer, if needed, this can…
This is an under the desk attachment for ESD wrist straps. You will need a banana female jack to finish this design. I created this cause ESD Hubs cost $20+ online. Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: Doesn't Matter…
To wszystkie aktualnie dostępne wyniki.
