Liczymy pasujące modele…
I was looking for a good excuse to use the ASA I have sitting around so I modeled and printed some MLOK Rail Covers. I aimed for something that would be slightly grippy, but not a PITA to use or clean. These parts are printed with…
This part is designed and optimized for ASA printing with a 0.6mm nozzle. This is a redesign I made for mounting the RaceBox Mini S to the outside of my car using the Ansix Auto suction cup mount (which is just a generic suction cup mount…
Simple two-part spout I designed to make pouring from the 1-gallon bulk bottles to smaller bottles a bit easier. I used a two-part design to allow the spout to rotate to the correct orientation for pouring. Assembly is as simple as…
Tired of your Essential Film Holder moving while scanning film? Me too! I designed this tool to keep the Essential Film Holder from moving around while using the CineStill CS Lite to illuminate the film. Finally, I can focus on sliding…
I purchased a set of used wheels that came with metal valve stems, but did not have the metal valve stem caps. The company charges $20 for each valve stem, and does not sell the caps separately. So I made a valve stem cap that closely…
This model is designed to be printed in ASA. Dumping boiling (or near-boiling) water down the drain is 100% going to deform PLA, and will likely deform PETG as well. You have been warned. I was tired of dealing with a low-flow sink…
I could not find a suitable model for this DAYTONA 1.5T Aluminum racing jack from Harbor Freight, so I made one. Disclaimer: This is not guaranteed to fit other models of Harbor Freight/Pittsburgh/Daytona jacks. This has only been tested…
This part is designed and toleranced to be printed in ASA. Keep this in mind when downloading and printing! Replacement throttle lever for my 1990's Murray self propelled push mower. The arm had broken off years ago, but my father was not…
This is a simple thread on funnel for iK Multi spray bottles. It prints with no supports, and in less than an hour on a modern core XY printer. Recommend printing in PETG, but PLA will work as well. Ever try to transfer from a 1 gallon…
Picked up an older gas hedge trimmer as a project. It was missing the air filter cover, and the only ones I found online were more than I wanted to pay for one. So I modeled and printed it in PETG. Fitment is okay. There are some things…
To wszystkie aktualnie dostępne wyniki.
