Liczymy pasujące modele…
I'm using a third party Apple Watch charger and the USB plug end is too big for the default file. I added some modifier objects in Prusa Slicer and it worked well enough. The hole will accommodate a plug 15mm /.59in wide Grab the bottom…
Updated model by scaling size to 120mm L&W, replaced holes with slots, and sliced off the excess to 5-6mm height. The 6mm height is what I'm using now and fits well/tight against the side panel. 5mm was the original size but the sides can…
This is a trim piece that's designed to attach to the middle aluminum extrusion bar on a double INBXX. Required Hardware 1 - M3x10 (or M3x12 max but will leave a mark on the 2020 extrusion; M3x8 might work but have not tried) 1 - M3 T Nut…
I don't have INDX yet and I wanted a way to go ahead and add the sensor block to my PTFE run. The PTFE tubes don't stay put on the top holes without proper sized plastic collets that come with the INDX kit. I bought some online and it…
INBXX Roller and PTFE Spacers (for SpoolRoller Configs) Not all of my t-nuts holding the Rods and PTFE mounts are completely secure. Some of them may end up moving a little during active use and modifications of INBXX, so I wanted…
Spry mints have an uneven shiny surface that can get stuck in the mouth of the original model. It's also small enough to dispense two at a time. I've included two models. One with a slightly wider mouth to the original (pictured in red)…
As per original model, use 30% infill for base for weight, and 15% infill for the rest. This one was printed in PETG.
The cable for the PSU is not very long and is bulky. I wanted a means to mount the PSU to INBXX instead of the Core One. This mod is for the US version, but the EU version can be made using the included 3mf project file if needed. I also…
PTFE tubes are slippery AF. With regular use, chances are high that the tube will slip in either direction, requiring repositioning. The original mod placed a single threaded pneumatic connector at the rear, which stops slippage when…
The concept of the original remix was to protect the thermister from physical altercations with PTFE tubes. The use case for this mod is to help protect the probe from direct exposure to the print head fan exhaust, without completely…
Dovetail version Uses the same end piece from the original. The middle piece is dove tailed in the middle and secured together with a decorative piece and screw. It's still held in place by one screw, but due to being cut in the middle,…
The original version will work along with AF installed but it introduces a bend and longer PTFE length that could add unnecessary friction to feeding filament. In order to avoid this, I placed the pass through holes closer to either end…
Mount a standard 80mm computer fan to a 2020 extrusion bar using M3x8 screws and metal T-Nuts (or 3d printed). The original model used a fan with rubber corners, so there is a small gap if the fan does not have this. I used four M3…
The original design does not hold anything in place, so if the roller falls out when moving, so do the bearings. I increased the diameter of the pegs so that they fit snug (red pic). Take care pressing the bearings onto the roller, as…
140mm fan bracket to attach to 2020 extrusions using M3x8mm screws and T-nuts. I had a spare Fractal 140mm case fan and wanted to try adding it to the double INBXX to help push air around (down). This fits perfectly on the middle bar (on…
This adapter allows attaching a spool holder directly to the OneTop mod instead of having to remove it completely to mount a spool to the Core One frame. I've tested the fit with this spool holder/roller (…
To wszystkie aktualnie dostępne wyniki.
