Liczymy pasujące modele…
The nozzle endstop for the Ender 3 pro moves the Z trigger point from the X axis bracket location on the stock design to the nozzle. This has the advantage of allowing for compensation of themal expansion of the nozzle when the machine…
The original HeroMe Gen7 X carriage for the Ender 3 Pro did not work for me as expected. I found several issues with fit and clearance of screws when used with certain direct drive options. I designed this part to be printed as one piece…
Have a Creator Pro that want to breathe new life into? This bracket is designed to use the existing mounting points on the printer but allow the installation of an SKR Mini E3 v3 motherboard and a Raspberry Pi 3 / 4 or Bigtreetech Pi…
I created this set of brackets to hold down the heatsink on my Raspberry Pi 3B+. Originally the heatsink came with adhesive tape but never really held on too good. When I replaces the tape with silicone pads the heatsink kept falling off.…
This is a wall mounted antenna base I made for the standard antenna that comes with the RTL SDR v4. Keep in mind while this mount aims to be simple it will require you destructively disassemble the stock mount. This is because other than…
I made these brackets to fix a Cyberpower CPS1500AVR battery backup device I purchased used. The L bracket / hooks that hold the front faceplate on were broken. Since straight gluing them would not be strong enough I created these small…
I needed to replace the power cable on my Denon DP-35F turntable. The old cable ended up being a little smaller than the replacement. So I designed a new cable clamp to prevent the power cable from being pulled out and damaging the…
I installed a Panda Breath unit in my Centauri Carbon. I had seen other options to allow for routing the power cable but was not keen on the majority of the power cable remaining in the machine, I also didn't want to cut the power cable…
Since the hexagon on the back can be quite brittle it should be printed vertically with the hexagon at the base. The part is designed so the Luer Lock part is to be glued on or welded with acetone if you choose ABS. I tried to print the…
To wszystkie aktualnie dostępne wyniki.
