Liczymy pasujące modele…
I could not find Stream Deck XL stand that would fit my needs. This is very, very simple solution for me to align it with my keyboard at desired angle. It is 10° angle towards me to get a less glare and have better visibility to my…
This is a relatively simple storage box for CR2032 and LR44 batteries. It holds 15 CR2032s and 20 LR44s. Only two magnets arranged in a cross pattern are needed to hold the lid securely. There's no need to glue the magnets, as the holes…
For my second remote control, I was missing a holder to mount with double-sided tape in my car, so I made one. In the photos, you can see a tiny gap between the remote control and the case. I didn't want it to be too tight, as I plan to…
As original models did not fit my measuring tape I decided to do my first remix. Inner diameter: 34mm For metal part of the tape it is: Height: 12.9mm Lenght: 10.70 See photos section I used M3x6 torx screw for the handle M3x8 torx screw…
These can be installed on either the left or right side. Two versions are available below: M3 Left Right M4 Left Right You might be wondering which placement is better—left or right. Personally, I find the right-side placement to be more…
This is a remix of my preferred mount for the Prusa XL. I use the Tapo C200, which is a similar style of camera to the original but has different dimensions. I kept the large middle hole to easily remove the base plate if needed. There…
I got tired of finding this remote each time around different compartments of car so I decided to make a holder for it. It is actually easy to put it in as well as slide it out. I used doublesided tape from AliExpress but feel free to use…
Girlfriend wanted to get the rid of a cup where all the dust were getting and she wanted to get something printed so I have designed this very simple holder for up to 12 different interdental brushes.
In the past I was struggling to find this scoop by De'Longhi so after all I decided to make one for my self so I can do a holder. You can find holder for this scoop here:…
These can be installed on either the left or right side. Two versions are available below: M3 Left Right M4 Left Right For an alternative, you can also check out my original remix, which allows you to use silicon nozzle wiper for A1 (Not…
Jelikož mě štvala voda, která při manipulaci s baterií odkapávala na desku, nakreslil jsem velice jednoduchý kus, která pasuje na baterii AVITAL Solona - odkaz zde a keramický dřez z IKEA - odkaz zde . Model obsahuje lehký “lip”, aby se…
Hi As I could not find any box that would fit my needs I had to do it my self :-) I printed PETG but you can do PLA or anything that makes sense to you. Top lid has bigger cutouts in order to easily open Lid in certain “angle” without…
I had to order some CR2450 batteries since I will need to replace them in IOT devices from TP-LINK. As I already made box for CR2032, LR44 etc. I decided to apply same design to fit CR2450. Again I used round magnes 5x2 mm. There is no…
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 159.61x250mm in size You may print at higher layer heights below the Base Thickness of 0.8mm The Max allowed Thickness is 2.56mm and the Actual…
Simple holder for this particular wrench. It may fit more models of this size. You will need 2x M4 bolts (M4x8 or M4x10) for 3030 alu profile. No supports needed
To wszystkie aktualnie dostępne wyniki.
