Liczymy pasujące modele…
This retrofit converts a Snapmaker J1 from rear-mounted filament to a front-loading spool system. The two filament holders utilize the empty space inside the printer to the left and right of the bed and can be loaded from the front which…
A simple plug for the 4 pin connector on the left side of the LilyGo t-deck plus. Print in a soft (85A) TPU - easy print no supports or raft required Category: Mobile Phone
Several different antennas leave a gap in-between the bottom of the antenna and the top of the t-deck plus case. These gaskets fill that gap to give the antenna installation a more "finished" look. Shown here are two typical types of…
Because the camera bracket is threaded, print with “Fine” mode in Luban. I used Silver Silk PLA for the bracket and white PLA+ for the camera frame. But you can print in any PLA+ or color you like. There is one support required on the…
Attaching this to the end of a painter's telescoping pole, allows a solar powered device with a standard camera mount to be attached at 45 degrees (for proper alignment to the sun). This method allows one to position the unit at various…
For those who would like to filter the output of the exhaust vent on the Snapmaker U1, this adapter easily enables it. It is a low-profile external solution that uses a readily available off-the-shelf filter that is available on Amazon…
By utilizing the two bracket holes at the back of the J1 Printer - one can create a dual-filtered exhaust using off-the-shelf HEPA/Charcoal filters. Additionally, by removing one filter, adding a rear duct, and turning one fan off one can…
Single-gang pass through for direct wiring of cables to power. I had an under the ceiling application in which I needed to run cables to the box alongside a Decora receptacle (see photos). Print Settings Printer: SnapMaker J1S Rafts: No…
If your door is rubbing on the bottom edge, and there is no more adjustment left on the hex set screw on the door-side hinge, simply add this between the lower hinge and the door frame to raise it. Usually 1 does the trick. If you use two…
If your 3D printer is a constant "construction zone" why not replace the feet on your printer with the yellow/black construction caution theme. This replaces the four feet on the bottom of the Snapmaker J1/J1S with feet that have a…
Some U1 hoods do not fully seat onto the four flexible mounting points on the top of the printer. This adapter bridges the gap and allows the hood to fully seat to the printer. It is a two material print - the top is TPU so it goes up…
Allows the placing of an analog Thermometer/Hygrometer on the front door of the Snapmaker J1 printer. https://www.thingiverse.com/thing:5878933
If you have a mobile raised bed from Costco (Cedarcraft model CC_SW2147A) with the bug screen option (CCGC-21-B) then these clips will hold the screen down against the side of the bed to keep birds and small animals out. I printed with…
Adapter sleeve made to create a replacement ground lead for an Obsolete Tektronix P850 probe. Designed to fit the female socket connector end of a Tektronix part number 196-3113-02 which is being repurposed for the ground lead: cut the…
This flat gasket (shim) mounts between extruder 2 and 3 at the rear of the unit around the top lid connector (see photos). It closes a potential leakage there between the lid gasket and the printer. Not everyone will need it, but I did…
To wszystkie aktualnie dostępne wyniki.
