Liczymy pasujące modele…
This is a 3D printed model of the P-51D Mustang from WWII. It features the fin offset and the wing washout of the original P-51. The entire model can be printed without the use of supports. I printed the entire model in PLA. This model…
At first, this piggy bank appears impossible to open, with a dovetail joint on all four sides. In reality, this is a simple box with two parallel dovetails, spanning the same direction as the coin slot. Print Instructions: Print both…
Rotary Photo Album The Rotary Photo Album is designed to store Instax Mini Photos. Turning the device simultaneously lowers pictures while raising new ones. Prints I printed this on my Bambu P1S. I tested that the top and bottom could be…
Deburring Tool Case I designed this tool case for a deburring tool and its replacement heads that came in a cardboard box. This tool case has a print in place hinge. Magnets hold the case shut while providing a satisfying snap as it is…
Geometric penguin chick design. Category: Animals
Model based on the P-3 Orion and CP-140 Aurora. Plane prints well flat on the bed with supports enabled. The props can be printed and attached to the plane using toothpicks. Some toothpicks may need to be sanded slightly or squished in…
Introducing the Jet Engine Piggy Bank! Inspired by those "lucky" travelers who toss coins into real jet engines, this 3D-printed marvel combines aviation and savings in one sleek design. Shaped like a turbofan engine, this piggy bank is…
The Iris Heart Box is a container that easily opens and closes with a small twist. In the open position it resembles a flower. The mechanism can be operated with a single hand. The print requires about 100 grams of PLA depending on the…
The Mini Iris Container easily opens and closes with a small twist. The mechanism can be operated with a single hand. The print requires about 100 grams of PLA depending on the settings. This is a good option for desktop storage while…
This model only uses 8g of filament and takes about 2.2 hours to print. This model can be difficult to get a good first layer due to the thin structures. I have found that turning off the Optimize Wall Printing Order setting in Cura would…
The Twist Open Iris Box uses a similar mechanism to a camera shutter to open and close. The top half of the container can be turned, causing a ring gear to drive the leaves and open or close the lid. The lid opens very quickly with…
See the PDF file for print and assembly instructions. If you own a Bambu Lab printer, I have the print profile on Maker World ( CP-140 Aurora Model Plane by RADdesign - MakerWorld ).
SUP Cup Holder Paddle the open water while your drink rests safely in the SUP Cup Holder! This is designed for the iROCKER Nautical SUP which has M8 threaded attachments. I designed it to fit a can with or without a stainless steel can…
To wszystkie aktualnie dostępne wyniki.
