Incense Holder
My second take on the incense holder. Decided to take the minimalistic and clean approach.
- Pobrania
- 822
- Polubienia
- 111
- Ocena
- 4,25
Liczymy pasujące modele…
My second take on the incense holder. Decided to take the minimalistic and clean approach.
It is a delicate print so make sure your bed adhesion game is on point!! You cannot be rough removing the print from the bed, or you run the risk of breaking the print. I also beefed up the outer walls of the moon support. They looked a…
Just a quick fun project. I may dabble a bit further and do a stand for the storage. For the hole, you may need to drill. The hole should be big enough, but due to the angle and small surface, it may create a seam or occasional blob that…
This was quite a lot of fun to make! This should be printed at slow speeds. To save filament, print the test print first to make sure the layers do not stick. There is only one layer gap with minimal contact area. If it does stick, use an…
A compact holder designed to accommodate a hex-shaped deburring tool and a set of 10 blades. This stand is designed to accommodate a 12mm wide handle, ensuring a looser fit and allowing for effortless removal thanks to its intentionally…
Something simple to add to any jar. These specific measurements are for 60mm, but it can be scaled up/down
Recently I struggled to insert 5mm magnets into my print. It is doable, but so much hassle, especially if it flips and u lose which side was the right one, especially when you have connecting parts. I designed print-in-place tweezers,…
My take on storing rings. Went with a lightning idea with its organic spread. The bottom of the cloud should be printed with supports, and the lightning fit should be snug but can be glued. In Theory, should be a stable stand.
My second take on the lid contest. I quite love this one, simplistic yet very effective. Version A: has a slot on the lid to cover the gap Version B: Has the notch covering the gap My Print (pictures) does have a few spaces, but that is…
This model fits jars that have 61.5mm diameter and 64.5mm with thread. Works great as a concept, but my initial 1x5mm magnets are too weak to make it snappy. Once I get my hands on 1x8 magnets, I will re-print the lid. Perhaps add…
To wszystkie aktualnie dostępne wyniki.