Liczymy pasujące modele…
Lots of people have been saying this controller is almost perfect but has too much slop…so I decided to do something about it. ____________________________________________________________________________________________ I have 2 parts…
Better grip for your thumb
This is a 3mf file for Bambu X1C to print ribs 1-6 standing vertically at 0.16mm layer height, 0.4mm nozzle, 200% scale. All manual supports/brims are already setup ,as well as variable layer height. I made sure layers never go over…
Usually one of the teeth break off over time. There are 4 gears in the unit. Check which one is broken for you. This gear is the one that drives the large gear with the lever arm. It has 13T on one end and 41T on the other end. The model…
2.5* low profile angle wedge riser for fine tuning turn/lean ratio on your longboard/skateboard/esk8.
This file is for a 200% scale Makerbot t-rex fossil. I modified the geometry of the 7 connectors to fit much more tightly to hip/femur/tibia/foot and head/neck. You will probably need to use some pliers to slightly squeeze the connectors…
Tighter fitting connectors for the t-rex arms of Makerbot's T-rex fossil. These are sized for a 200% scale T-rex. They will hold the arms in place with friction fit so no glue should be necesary and the arms won't flop around like the…
This adapter ring lets you use 6mm instead of 10mm magnets if you don't feel like buying 10mm magnets. Magnets need to be press fit with pliers. The adapter ring should be press fit into your part as well but may need a little glue or…
For Makerbot's T-rex fossil. The 3mf file is for Bambu X1C. I used Inland bone white, 0.4mm nozzle, 205*, 60* bed, 0.16mm layer height, and is for a 200% scale t-rex so adjust scale proportionally if you need to. The models can be saved…
This is a 3mf file for Bambu X1C to print ribs 7-11 standing vertically at 0.16mm layer height, 0.4mm nozzle, 200% scale. All manual supports/brims are already setup ,as well as variable layer height. I made sure layers never go over…
This is my scale modified connector for tail part B to C. It is for a 200% scale Makerbot t-rex fossil. It will fit much more tightly compared to the stock file. Scale down just a few percent if you don't want such a tight fit.
Update 6-7-23: Added a new file which is a slightly longer and wider version that matches the width of the Kali IN-5 better(200mm wide) and is slightly longer than my original upload also. Also did some minor modifications to the part to…
Made a jig to allow me to drill a new set of holes on my longboard to give an extended wheelbase. Bolt the jig to your existing truck mounting holes and then use your drill to drill a new set of holes that are 3/8" further out. I would…
This spacer goes between the Newbee 4GS motor mount plate and the motor and prevents the pinion gear from contacting the inside of the gear drive cover when using Reacher/SkyartPower/Radium motors. I recommend setting the Z height of the…
I made a template to route out a drop through opening on the ends of my longboard. This jig will give you the open ended style drop through openings, allowing you to slide the trucks on without disassembling them. I have only tested the…
To wszystkie aktualnie dostępne wyniki.
