Liczymy pasujące modele…
I ordered an Anycubic Kobra S1 Combo, and saw reviews that said the ceramic replacement hot-ends were a decent ‘quality of life' improvement due to the faster heatup and cooldown times. So, I ordered a set of those. And I need to keep…
Intro I own 2 Lenovo ThinkVision X1 Gen2 monitors that I am quite fond of. The stand is not bad, but I just wanted to mount them on a dual arm monitor stand with a VESA mount. Unfortunately, the X1 only has the option to use the…
Heavily inspired by TacticalBeanies mount here , I created this vertical mount for the BigTreeTech HDMI7 touch screen. Note that this version will NOT fit the v1.2 (or newer, probably, should one ever come out). My model assumes the…
Intro: I purchased the cheap and cheerful Lerdge Aquarius because it was… Euhh.. Cheap and looked cheerful! I wasn't a fan of the standard mini stealth burner extruder, so wanted to replace that and this was the quickest solution for me.…
I was ‘remodeling’ the extruder on my Dragonburner for my Voron 0.2 again (seems like a monthly thing these days) and decided to go with a Sherpa Mini extruder. I realised I needed a mount to get my BTT EBB36 v1.2 on it, and something to…
I used @PacoSebas_548699 excellent mounts to put a 76x56 Skadis in the back of my 85x55 Bror case. I also wanted to have the narrower 36x56 in the side of it, however that obviously wouldn't fit (too much space to bridge). So I remixed…
After printing and installing the original ball joint design, I decided I liked it, but I ran into a small problem with it. I drilled the hole into the top panel roughly in the middle of the top panel. While printing, generally, the…
Introduction This is my second remix of the excellent Orbiter mount made by @niefachowy since I like it so much. Since my earlier remix I have now started using a Dragonburner toolhead as well as the alternative mounts for them.…
Warning! If you use these parts, you will need the rest of the mods that go with it, you will change the geometry of your printer motion system and you will need to make sure that the edges of the bed, the end stops, the belt tension, and…
Warning! If you use these parts, you will need the rest of the mods that go with it, you will change the geometry of your printer motion system and you will need to make sure that the edges of the bed, the end stops, the belt tension, and…
Introduction This is a filament buffer that is suitable to be used in conjunction with a BoxTurtle MMU and the AFC Klipper addon , specifically as described in the ' Buffer Ram Sensor ' section. It features 2x D2HW-C201H switches and 2x…
Introduction Yet another '10" rack SBC mount'. There are plenty of mounts for 10" racks out there, many quite good, but none that quite fit my needs. I needed a mount for a variety of SBCs, some with HATs, some with NVMe drives that poked…
To wszystkie aktualnie dostępne wyniki.
