Rolohaun Calibration Cube
Here is the official Rolohaun calibration cube
- Pobrania
- 440
- Polubienia
- 51
- Ocena
- 5
12 modeli
Here is the official Rolohaun calibration cube
This is a full rework for the Rolohaun & Fabreeko MK1 Rook kit. This geometry allows you to house EVERYTHING of importance to be neatly stored in the base. This adds weight, symmetry and safety to this printer in my opinion. It looks…
I wanted to use a DIN rail mounting solution similar to the Trident for my SimpleCore Redux, but was unable to span two pieces of DIN rail across and still fit all of the electronics due to the belted Z-axis assemblies underneath the…
BOM: Qty 2 - M4 Hex Nuts Qty. 4 - M4 Knurled Nuts: https://www.mcmaster.com/90368A200/ --OR-- Qty. 4 - Silicone Bed Spacers CR-10 Hotbed: https://a.co/d/25VRBL Print Settings: Material Used: Inland (Micro Center) PETG-CF I just followed…
Revision Log 2026-02-09 -- Initial Release 2026-02-10 -- Added vertical ribs for stiffness. BOM: Qty 6 - M3 Brass Inserts Qty 12 - M3 x 8 Flat Head Cap Screws 4 to attach each motor to the carriage. 2 to attach each retainer to the base.…
These are meant to be attached via 2 m3x8 screws and 2 heatset inserts in the bottom frame. I bet that a friction fit using only the frame rods would work just fine though, and that way you don't need to reprint your whole bottom frame.…
I modified the original mount created by NoobEnginer on Thingiverse to fit the 1.2 version of the BTT HDMI5 screen, as well as changed the base to shorten it and remove the arm and swivel feature. I also modfied Kanrog's modular top by…
Moves the stock endstop mounting holes out 7.6mm in order to save you from printing separate standoffs. Endstops screw directly into the plastic, as this they aren't something you should need to unscrew after the initial installation.
The feet sit up nicely against the skirts, so they will not rotate once attached. BOM: Qty 4 - M6 Nylock Hex Nuts Qty 4 - M6x20 Hex Bolts or SHCS Print Settings: Material Used: Overture TPU 95A Layer height: 0.2mm Infill percentage: 15%…
I modified the original carriage with M3 hex nuts instead of heatset inserts for attaching the arms to the carriage, which I find to be more convenient and expect to be equally strong. The centers of the screw holes are in the same…
I've been getting bored with hexagons, so I put together a new skirt & feet design for the SimpleCore (2025 version). Inlaid Rolohaun's logo in the center of each side, as well as an "S" and "C" in the "cool S" font from the 90s. Also, I…
I've been getting bored with hexagons, so I put together a new skirt & feet design for the SimpleCore (2025 version). Inlaid Rolohaun's logo in the center of each side, as well as an "S" and "C" in the "cool S" font from the 90s. Also, I…