Outdoor Sensor CR123A Battery Box with Hood
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For temperature and humidity sensors outdoor use
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 18
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this for an Aqara temperature/humidity/pressure sensor but any other may work.
It is not rain proof, but adds some protection against rain on windy days under the eaves. The bigger battery is a must in cold winters.
Made a hole on the sensors battery cover to feed the wires into the sensor, soldered the wires to the battery terminals in the sensor and simply attached the sensor to the box with double sided tape (which was already applied by the manufacturer on the Aqara).
The hood is optional and slides on/off as required for example to push a button on the top of the sensor.
A pair of 9 mm wide battery spring contact plates are required (see photo). Bend the ears of the plates at 90°, solder the wires to them, and simply push them into their recesses. See the +/- markings under the battery compartment.
To attach the lid M3 threaded inserts and screws are needed.
Printed in PETG with 3 perimeters 20% infill without supports.