Ender 3 Hex Wrench Handles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wera screwdriver style handles for the standard hex wrench set that comes with the Ender 3. 1.5mm 2mm 2.5mm 3mm 4mm…
- Rating
- 4 / 5
- Likes
- 44
- Downloads
- 250
- Makes
- 2
- Views
- 1,767
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Wera screwdriver style handles for the hex wrench set that comes with the Ender 3.
- 1.5mm
- 2mm
- 2.5mm
- 3mm
- 4mm
- Bonus replacement handle for the screwdriver that comes with the Ender 3. Heat the shank to separate the blade from the original handle, then melted in or glue it into the new one.
Print Settings
Supports: No
Resolution: 0.25mm
Infill: 25%
Print in 2 mirrored halves for each size wrench. Don't forget to mirror one side! Each full handle takes 1 ½ to 2 ½ hours to print as they scale up by 10% throughout the set.
Post-Printing
Fit the wrench in the handle.
The fit is intentionally tight so by lightly heating the wrench just at the bend with a lighter/candle/stove (not red hot, just warm enough to melt plastic). Then press the two halves together around the wrench, it will melt into place with a tight fit. Sight down the length to make sure it is straight as it cools.
Separate & Glue
Separate the halves (use a scraper if the halves got melted together around the wrench). Finally, glue them together with CA glue.